Re: Clint Dixon


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Clint Dixon (Curator of Antiquities) on Tuesday, November 14, 2006 at 8:15PM :

In Reply to: Clint Dixon posted by Glen on Monday, November 13, 2006 at 11:18AM :

For the Monarch pump that powers my Good Roads plow, I am using a belt that was made by Gates and distributed through NAPA. It is a 4L210W. The information on the back of the package reads: 1/2" x 21", 12.5/13mm x 535mm. Whether this will work for you depends upon the diameter of the body of the generator you are mounting the pump to, the pitch diameter of the additional drive pulley added to the generator, and the pitch diameter of the driven pulley on the pump. I am using a modified Browning BS32X1 steel pulley added to the generator (3-11/32" approximate O.D.) and a Browning 1VP34-1/2 cast adjustable sheave on the Monarch pump. The sheave is adjusted to the minimum pitch diameter in order to work the belt on and off and adjusted almost to the maximum pitch diameter to tighten the belt.

I have a few pieces of literature. I will see what I can do to get them posted.

Junior





Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com