Posted by Kaegi on Friday, June 09, 2006 at 7:47PM :
In Reply to: Help reading a rebuild tag... posted by Chris Davis - UT on Friday, June 09, 2006 at 5:16PM :
right .010 undersized rods and .010 undersized mains. Can't read above the .020 but probably .020 over pistons. you can find on Ebay rod and mainbearings that are .011, .012 undersized. But you need good calipers to measure the journals to see if they will accept suck bearings. I have tried rolling in the same size bearings a couple times and had almost no gain in oil pressure. Do you have the stock fuel filter on your truck? if so clean it out. if you have disposable type change it. sounds like you sucked up some crud into the fuel pump and/or carb. also clean glass bowl and screen on fuel pump