Re: Brazing, with oxidizing flame

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Spence on Wednesday, May 03, 2006 at 11:24PM :

In Reply to: Brazing, with oxidizing flame posted by chris case on Wednesday, May 03, 2006 at 10:56AM :

I never use an oxidizing flame to braze, burns up rod and work piece. 5 pounds oxygen pressure and 5 pounds acetylene pressure for light gauge work. I use a neutral flame, low volume. Makes a slight noise, not a hissing sound. Use flux coated rods, diameter sized for application. Clean work piece very well. No rust allowed. Have repaired oil pans this way.

Spence

Follow Ups:

I agree - David Sherman 12:19PM 05/04/2006

I'm batting 1,000 since cranking up the oxy - chris case 1:19PM 05/04/2006
- That sounds about right - David Sherman 4:52PM 05/04/2006

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com