Posted by garrison on October 17, 1997 at 16:38:48:
In Reply to: Full-time Rattle posted by Trent on October 17, 1997 at 15:27:07:
Describe:rattle Is is a tin kind of a rattle? is it a very heavy metallic rattle? etc.
: *(This is a repost for those of you that recognize it)*
: I have a '75 Dodge, full-time, 3/4 ton. Last summer I swapped in a Dodge '74 part-time front axle (with full-time drive
: flanges from a Chevy) for the wider bearing set-up. I also in stalled a 4" lift at the same time. Now I have a rattle in the front
: end some where when I'm coasting faster than 40 mph (similar to a bad u-joint). I've replaced all u-joints, a slopped out yoke,
: the slip spline and lengthened it, and had a good drive shaft shop inspect the CV. With the lift the CV had to be clearanced
: with a grinder to allow for droop. I still had the rattle. I reputable mechanic inspected it for me and claimed a worn t-case,
: repaced it with a rebuilt unit from Boyce Equiptment and I still have a rattle. Help, no one knows where this rattle is coming
: from!!
: Trent
: slwc1@cc.usu.edu