Posted by Vaughn on Sunday, February 19, 2006 at 6:03PM :
In Reply to: wiring harness help needed posted by Steve Pellock on Sunday, February 19, 2006 at 4:58PM :
Hi Steve,
This should be the conversion. Verify it w/Eric's diagram
On positive ground, power goes to negative terminal post, positive side goes to ground. The ammeter should have - & + stamped next to the terminals
On/off ignition switch
A - from + side of ammeter to switch
F - from switch to negative terminal of fuel gauge
C - from switch to negative terminal of coil
accessories/off/on ignition switch
GA - from switch to negative terminal of fuel gauge
RAD - goes to radio
AM - from + side of ammeter to switch
COIL - from switch to negative terminal of coil
Follow Ups: