Posted by Scott in Georgetown on Sunday, February 12, 2006 at 9:54PM :
In Reply to: Re: Question about pulling 230 engine('57 WM300)... posted by Dan Shockley on Sunday, February 12, 2006 at 9:23PM :
I have obviously stumbled upon a suprise!...
The transmission is supported with a jack.
I have removed the radiator and sheet metal.
I have an appropriate hoist.
The front mounts are removed and the front of the engine is free.
The engine will not uncouple from the tranny!....
Are there are additional bolt(s) between the engine and transmission that I am missing(but it is not obvious)?
Can the engine be removed without the tranny?
I can easily pull both tranny and engine as a unit, but I would like to only pull the engine.
Thanks!
Follow Ups: