Posted by jim in n.y. on Tuesday, February 07, 2006 at 8:31PM :
In Reply to: pinion seal posted by RICHARD BOWMAN on Tuesday, February 07, 2006 at 8:09PM :
rich, i'll assume the seal is new. unless you damaged it when you installed it it should be ok. pull the yoke off and make sure there's no groove worn where the seal rides. if so then put a speedy sleave on it . i also put a little sealer on the splines as they sometimes weep oil out past them.if you need to pull the seal tap 2 5/16 -24 holes in the seal 180 degrees apart and use a brg. puller to pull the seal out . it works great. i just did 7 seals and speedy sleaves on my 6x6. no leaks so far. good luck, jim .
Follow Ups: