Posted by Willy-N on Saturday, October 08, 2005 at 11:00AM :
In Reply to: Re: Willy-N the Frame and installed my Bumper posted by Ugg on Saturday, October 08, 2005 at 10:46AM :
My back is sure sore this morning with all the bending over welding the bottom! Takes a while just to figure how to lift the sheets to weld them in place with as little man power used as posible. The back hoe won't fit in the shop and that is where I am welding it together. I will pull it out to flip the bottom but the rest will be done inside except putting the lid on top. It has to go on twice. Once to drill the holes around the edge then removed, weld bolts in the angle iron inside and re/drill all the holes on the lid bigger so it will slip back over the bolts easy when it goes on for good. Mark H.
Follow Ups: