Posted by Doc Dave on Friday, September 30, 2005 at 9:23PM :
In Reply to: U-Joints and seal material posted by Will (in MI) on Friday, September 30, 2005 at 8:49PM :
I had the same problem. I could not find anyone that had the seals, I checked with several of the usual "power wagon" vendors.
I ended up getting some 1/4 " sheet cork rubber from Car Quest.
I am going to shave it down to the proper thickness which I think is about 3/8".
So the NAPA number is good? I would not want to use older cork, it is too brittle.