Posted by AAA on Friday, June 24, 2005 at 12:43PM :
In Reply to: Rear Hubs posted by Country on Friday, June 24, 2005 at 12:12PM :
if on a 59-68 W100, 57-71 W200, 58-71 W300, 57-71 W500, or a 46-71 WDX-WM300, you will need to remove retaining nuts (6-8) on the drvie flange of the rear axle shaft, then remove the hub locking nut, lock washer, and bearing retaining nut, and the hub should come off.
the procedure for a 57, 58, 69-71 W100 will require removing the cotter key, nut, and the use of a slide hammer to pull the axle shaft with pressed in bearing. Not sure if a c-clip was used on the inner side of the axle shaft on 69-71??
AAA