Re: Installing a PT0 into a I Ton PW


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Steve Elliot on Thursday, February 17, 2005 at 10:11PM :

In Reply to: Installing a PT0 into a I Ton PW posted by Jim Davis on Thursday, February 17, 2005 at 12:42PM :

Jim,
It is possible to do. The top bolt is really hard to get at. Take the floor pans off to help at getting at that bolt. You might use a threaded stud with a nut instead of a bolt. I thought it was impossible when I did it but I managed to get it installed. Two people would help too.
Good luck,
Steve in Boulder Creek, Ca.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com