Posted by OTM Mike Stone (Idaho, USA) on Tuesday, February 01, 2005 at 3:22PM :
In Reply to: What Has A 124" Wheelbase? posted by Larry on Tuesday, February 01, 2005 at 9:04AM :
go to pauls site
has all the frame data and what / where to
take measurements not hard to do
first a quick way to see what it what
get rig on flat clean concrete surface
get a plumb bob drop down from center of each
axle hub - mark ground with little 'X's then measure fore & aft (will give you an accurate wheel base and then the diagionals to see if what you have is tweeked
at the same time check the frame for non factory welds
you might also get a build card (25 bucks) to
see what dodge built as the build card has the wheel base on it
low serials on any collector type vehicle help to determine the value
and 11 is low