Got to be a better way to set timing on M37!!


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Willy-N on Tuesday, December 28, 2004 at 3:47PM :

I have done this quite a few times in the past but there has to be a better way of doing it!! What is the easiest way to line the oil pump up with the dist shaft and still have #1 on the dist where it should be. The way I have done it in the past after putting it on TDC is to turn the pump till it is close shove it in and try the dist to see if it is right. If it is not right pull the pump again turn it a little, put it in again and see if it lines up this time. This can go on for quite a few tries. Then when you think you got it right and start it, it pops and you start all over again!!! There has to be a better way of doing this because once you start it then lots of oil comes out when you pull the pump again all over the floor!!! This is the last thing I have to do and it is running again. Any help on this? Is this a 2 person job to make it easier?? Thanks, Mark H.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com