Some are 'upset' rather than set

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by chris case on Friday, October 08, 2004 at 2:06PM :

In Reply to: OT setting saw teeth posted by Clint Dixon on Friday, October 08, 2004 at 1:56PM :

Some teeth are hammered on to bulge the steel- hammer towards the axle on the 'clearance' side of the tooth, lots of light taps. Others you can lay the blade on an end grain block, and hammer the tip of the teeth into the block- do alternate teeth then flip blade over. Some have interchangeable teeth, you use a special lever to cam/lock them in.I doubt that the usual saw set would be big enough to work on teeth 1 inch long, but I don't know about specialty tools for Snidely Whiplash size saws.

Follow Ups:

Good free book from Simonds - David Sherman 5:59PM 10/09/2004

Re: Some are 'upset' rather than set - Clint Dixon 5:01PM 10/08/2004

Trying to make rocket science out of chopping wood? - chris case 8:31PM 10/08/2004
- Chris..... - MoparNorm 3:33PM 10/11/2004
Re: Some are 'upset' rather than set - Tim Holloway 5:34PM 10/08/2004
- Some smell good - wally 7:35PM 10/08/2004

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com