Posted by Vaughn on Sunday, September 19, 2004 at 11:13AM :
In Reply to: rear engine mount posted by Jim Chance on Saturday, September 18, 2004 at 9:51PM :
Hi Jim,
You have a rubber insulator that sits on the frame mount, a metal spacer on top of it that support the bell housing and insulates against engine noise. The M37 insulators will work fine or if you buy the rubber that mounts to a floor squeegee (1/4 thk x 2” wide or so) they work very well and you will need rubber hose the size of the bolt about ½ long to insulate the bolt from any metal contact. Cut a small square or round piece to insulate the lower frame mount. It should be placed against the frame mount, then bolt washer and nut. VPW sells the M37 insulators