early type transmission question


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Jim Chance on Friday, September 17, 2004 at 8:55PM :


I was putting my transmission together today and had a question. The manual has clear instructions for shimming the rear bearing holder with gaskets. The front has no such instructions, but has a gasket. I can't understand why the front bearing holder has a gasket - there is nothing to seal in or out - but if it did it seems you would have to put just the right number to hold the bearing tight and still close.

Any comments?

Jim Chance



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com