Re: Proper method to test FUEL sender unit?


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Steve on Thursday, September 16, 2004 at 8:45PM :

In Reply to: Proper method to test FUEL sender unit? posted by Davey-boy on Thursday, September 16, 2004 at 9:13AM :

attatch ohm meter to post and housing, securely. slowly move arm through full motion swing. The reading should gradually change in a smooth fashion as the arm is moved through its range. If you get to a certain point and the needle jumps around, it is probably corroded inside and moving the arm back and forth many many times may clean off the corrosion. If nothing happens when you move the arm back and forth the unit is dead. The problem usually lies in the wiring.




Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com