Posted by Vaughn on Tuesday, August 31, 2004 at 8:58PM :
In Reply to: where can i get a pinion bearing retaining nut Tool? posted by lui in oak cliff on Tuesday, August 31, 2004 at 4:35PM :
Do you know if the cone and cup need to be replaced. If not, I would leave it alone. Else you can use some 1/4 or 5/15 x 2 or 3 inch wide flat stock, cut 4 squares and weld to the end of the stock 90 degrees to each other so it fits the nut with a couple feet for a torque handle.