Posted by Tim Holloway on Wednesday, October 29, 2003 at 3:12PM :
In Reply to: HELP '50 PW Wiring Harness; frame mounting posted by Mike M. on Wednesday, October 29, 2003 at 2:47PM :
I used flexible aluminum conduit along the frame and held it there with plastic cable cips with a self drilling, self tapping screw. If you use the flex conduit, make certain you use aluminum and be sure to use the little plastic end sleeves to prevent chafing on the cut end. Pull your wires first, dont install the conduit and then pull the wires. To exit a wire along the way, like the fuel guage, I cut the conduit and inserted it into a piece of heater hose, it was a tight fit. I put a small hole in the rubber for the wire to exit. This has worked well, no tangle of wires underneath to snag and rip out. Looks cool too!
Follow Ups: