Re: Hey Tim,


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Tim Way on Thursday, September 25, 2003 at 10:52PM :

In Reply to: Hey Tim, posted by Clint Dixon on Thursday, September 25, 2003 at 8:48PM :

Clint,

I shot you an email. I went ahead and traced the wires out and here's what I came up with:

B=Blinky Light
C=Right Out
D=Both Left and Right Out
E=Common Input from the flasher
F=Left Out
G=Ground

Wire "D" really has me scratching my head. The wire is actually soldered to one set of the left and right out puts inside the switch. (There's two sets of out puts). Maybe they use it as the "Pilot" for a 3 prong flasher?

If your instructions don't work, I think I will cut wire "D" so it is a Right Out only, then cut "B" from the lamp and solder it into the Left Out that's now empty. I will use a small wire and solder it between wire "E" and the lamp so the Blinky Light still works.

Here's what the new pin out will look like:
B=Left Front Out
C=Right Front Out
D=Right Rear Out
E=Common Input from flasher
F=Left Rear Out
G=Ground

The only problem I'm having is figuring out how to make the brake lights work with this set up. I'll need some diodes in there somewhere I'm sure... Any pointers? I’m going to post this over on Big-E as well.

Thanks in advance!
Tim Way
Albuquerque, NM



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com