Posted by mark dingbaum on Monday, August 11, 2003 at 10:08AM :
In Reply to: Re: W300 exhaust manifold needed posted by steve on Friday, August 08, 2003 at 10:16PM :
Hi Steve,
Thanks for the generosity. I looked at the truck yesterday, it is 'center dump, with the forward outlet bolt closer to the engine than the rear bolt. There is only one slight 'rib' running horizontally starts out short and gets taller near the outlet, then tapers back short again. The ends of the rib are near the front and rear port entry.
I looked at some of my car/truck stuff and most of mine are very heavily ribbed, both around the bolts and through the main section of the manifold.
Can you describe your manifold?
thanks,
mark