Posted by Tom in Oregon on Sunday, July 27, 2003 at 11:13AM :
In Reply to: Re: Cylinder sleeves posted by Gordon Maney on Sunday, July 27, 2003 at 1:48AM :
Gordon,
Both. I don't quite understand your question, since they're the same piece of metal. The hole is in the cylinder wall, low, but the skirt is still all there. The guy doing the machining says it is ok to sleeve. He puts a step in the bore to keep the sleeve from moving down over time. He seems to know what he is doing. At this point I am at his mercy!
Tom