880 Extensions, and Parts for Will. Thanx


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Will Liebscher on Friday, July 04, 2003 at 5:12AM :

In Reply to: OK. And if anyone else needs parts, speak up now. posted by Brian in Oregon on Thursday, July 03, 2003 at 11:32AM :

Brian, I'll try and post this in both places. I measured my demo chassis today. I would like each side frame rail, from the aft edge of the front crossmember, 15" aft. That puts the rear edge (cut) of the driver side frame piece I would like, just behind the holes mounting the steering box, on the driver side. Passenger side same length. Both 15". I would also like the two B/H - spring perches. And if you don't mind, and no one else wants it, I'd like the bracket under the drivers feet, which mounts to the frame, to support the Cab, and to which the M/C attaches. It has a big hole in it for the nose of the M/C. It is the front bracket that the driver side running board also sits on. I'll take it bent or messed up. Naturally, it is not 90 degrees to the frame, if you happen to notice. I'm doing a piece of my original artwork/Design with this part.
And you asked where on the M37 frame are the pieces which will nest over the 880, and yes Civie, frames. These are the M37 frame rails aft of the curve over the rear axles. I separate the rear crossmember out, and save it also, as a replacement part for an abused M37, such as one who has had its pintle hole, or other areas welded up, cut up, or stuff welded to. Sometimes its easier to do it by replacement, than by using a plasma cutter. So I would only like the 5 parts, but 4 of them will do. I believe I can afford to have them shipped or creatively transported. Thanx Will Liebscher



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com