Re: Transfer case interchange?


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by rsteller on Tuesday, April 29, 2003 at 9:47AM :

In Reply to: Re: Transfer case interchange? posted by Vaughn on Monday, April 28, 2003 at 9:34PM :

Vaughn, yes, the WC61 is 1.5 ratio. It's identical to the 38631 case except the rear output port isn't machined out large enough to accept the 1.96 ratio gear, and it has a 3/4" eye cast in above the front output. I decided to go with the 1.96 ratio, as I've installed 4.89 gears, and wanted the lower 1st gear. Yes, I have the cast iron brackets, numbers match my parts book, and new rubber bushings from AB Linn (M37). It still seems odd that by moving the t-case forward about 1" it could move up about 1" inside the crossmember. Oh well! Just wanted to make sure I wasn't headed down the wrong path. BTW, I've gone to the centered rear axel, and made a hybrid 200/201 transfer case to eliminate the old rear output assembly. It required minor machining of the case and the front axel shift shaft. Thanks, Rob



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com