Posted by Drew on April 02, 1997 at 22:01:22:
In Reply to: welders posted by Dallas Meek on April 02, 1997 at 18:11:22:
I've had experience with both the Miller and Lincoln. Both work well and the $600 units are better. I prefer the Miller. The most important thing with these small units if your not using any type of gas is quality flux wire. This is a must, cheap wire will cause you more problems then the savings are worth.
: Can anybody out there give me some advice on a decent,
: reasonably priced 110v wire feed welder. I see some
: running from 295-325 at the farm supply stores but I
: have had some feedback that these are not too great.
: I am mainly planning on using it on sheet metal at
: this time. Appreciate any info you might have.
: Thanks,
: Dallas